In 2018, E-6 Processing is expensive. I shot this roll back in April and after shooting it, it sat in my freezer for 2 months, because I can’t afford to get too many rolls of E-6 processed at once. My E-6 film usually “marinates” in a ziploc bag in my freezer for 1-2 months before I have it processed.

I shoot transparency/slide film for nearly all my work. I started out in film photography a year ago with the typical colour negative films like Fuji C200, Kodak Portra, Ektar, ColorPlus, etc., then I one day tried a roll of Agfa CT Precisa 100 (which just so happens to be rebranded Fuji Provia 100F) and Iwas hooked, there was no going back.

I will never forget the shock of seeing those razor sharp images filled with colour backlit by a sea of white light in the dark.

Fuji Provia 100F is probably my favorite. It’s very versatile and works with any kind of subject. It can be pushed 1 stop (EI 200) in normal light with only a minor increase in contrast. It can also be pushed up to 2 stops (EI 400) however, I prefer to rate it at 100 for a 2 stop push.

These 5 images are shot normally at 100, with some bracketed towards underexposure. I normally use an 81A warming filter with Provia, but the warm evening light makes it unnecessary in this case. The way Provia 100F renders colour leans toward cool tones, it works beautifully in certain situations where Velvia would be a little too “over the top”, especially blues, which are the most beautiful I have ever seen. I shot these frames on my Minolta X-700 with motor drive 1+,  MD 50mm f/2.0 + Tamron 103A 70-210mm f/3.8-4 lenses.

~ Lauri  Lind

 

 

Get involved: submit your 5 Frames With

Get your 5 frames featured here. You can submit your 300-350 word article using this form.

This series is being produced in conjunction with Hamish Gill's excellent 35mmc.com. Head on over to read the other half of these stories there.

 

 

Write for EMULSIVE

EMULSIVE is all about knowledge transfer and developing more of it across the film photography community.

Help by contributing your thoughts, work and ideas to inspire others reading these pages: read this quick submission guide.

Lend your support

If you like what you’re reading you can help support EMULSIVE by heading on over to the EMULSIVE Patreon page and adding financial support from as little as $2 a month. As if that’s not enough, there’s also an EMULSIVE print and apparel store over at Society 6, currently showcasing over two dozen t-shirt designs and over a dozen unique photographs available for purchase.

 

2 COMMENTS

Add your voice